If any of the speakers to be connected has an impedance of 4 Ω or more and less than 6 Ω, set "Speaker Impedance" to "4ohms" for "Speaker Setup" in the Initial

Setup section ( →p175). When setting "Speaker Impedance" from the System Setup menu, press the

screen, and select "System Setup" - "Speaker" - "Configuration", then set "Speaker Impedance" ( →p136) to "4ohms".

„ Connect the Speaker Cables

1/2˝

(12 mm)

Make correct connection between the unit's jacks and speaker's jacks (+ side to + side, and - side to - side) for each channel. If the connection is wrong, a bass

sound will not be reproduced properly due to reverse phase. Twist the wires exposed from the tip of the speaker cable so that the wires do not stick out of the

speaker terminal when connecting. If the exposed wires touch the rear panel, or the + side and - side wires touch each other, a malfunction may occur.

Speaker Connections

button on the remote controller to display the Home

5.1ch

7.1ch

5.1.2ch

7.1.2ch

5.1.4ch

7.1.4ch