Advertisement
Manual MCACC
Height 1 Left, Height 1 Right, Height 2 Left, Height 2 Right, Surr Back
Right, Surr Back Left:
After selecting the speaker frequency from between "63 Hz" and "16 kHz" with
the cursors
/ , adjust the volume of that frequency between "-12.0 dB" and
"+12.0 dB" with
/ . To readjust the overall volume balance with "Trim", select
"Trim" in
/ , and use
/
to adjust the volume.
• If "OVER!" is displayed during adjustment, the volume of the frequency band
or another frequency band is too high, so reduce the volume of the frequency
bands until the display disappears.
• "63 Hz" can only be selected when this speaker is set to "Large" in "System
Setup" - "Speaker" - "Crossover".
• Depending on the use of the ZONE speakers, it may not be possible to select
this setting.
• If an item cannot be selected even though connection is correct, check
that the settings in "System Setup" - "Speaker" - "Configuration" - "Speaker
Channels" matches the number of connected channels.
Subwoofer:
After selecting the speaker frequency from between "31 Hz" and "250 Hz" with
the cursors
/ , adjust the volume of that frequency between "-12.0 dB" and
"+12.0 dB" with
/ . To readjust the overall volume balance with "Trim", select
"Trim" in
/ , and use
/
to adjust the volume.
• If "OVER!" is displayed during adjustment, the volume of the frequency band
or another frequency band is too high, so reduce the volume of the frequency
bands until the display disappears.
• This cannot be selected if "No" is set in "System Setup" - "Speaker" -
"Configuration" - "Subwoofer".
„ EQ Professional
You can automatically measure and calibrate the reverberation characteristics
(how the sound echoes) of the room. First measure the reverberations with
"Reverb Measurement", then check the results with "Reverb View". Specify the
calibrated time position in "Advanced EQ Setup" based on the measured results
to automatically calibrate the reverberation characteristics.
‰ Reverb Measure (Default Value: without EQ)
Measure the reverberation characteristics of the room. After making the
following settings, place the speaker setup microphone in the listening position,
and connect to the SETUP MIC jack on the main unit. Press ENTER and follow
the on screen instructions.
without EQ
MCACC is used to measure the reverberation characteristics
of the room without any adjustments made to the equalizer of
the speakers.
with EQ
Measures the reverberation characteristics of the room using
the adjustments to the equalizer of the speakers saved in the
MCACC Memory.
‰ Reverb View
The results of the measurements of the reverberation characteristics are shown
in graphs for each speaker and frequency. If there is no reverberation, the graph
stays horizontal, but if there is reverberation the graph rises to the right. If the
"Symmetry" calibration type has been selected and Full Auto MCACC was
performed, predicted values for the reverberation characteristics after calibration
are also shown.
Setup
163
Advertisement
