Advertisement
Miscellaneous
Miscellaneous
„ Tuner
(North American and Taiwanese models)
Change the settings for Tuner.
‰ AM/FM Frequency Step (Default Value: 10 kHz / 0.2 MHz)
Select a frequency step to suit your residential area.
Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
• When this setting is changed, all radio presets are deleted.
„ Remote ID
Change the remote controller ID.
‰ Remote ID (Default Value: 1)
Select an ID for the unit's remote controller from "1", "2", and "3" to prevent
interference between the unit and other Pioneer components that are installed
in the same room. After changing the ID on the main unit, change the ID on the
remote controller accordingly with the following procedure.
While pressing and holding the MODE button, press the following buttons for
approx. 3 seconds.
• To change the remote controller ID to "1": AUTO/DIRECT
• To change the remote controller ID to "2": SURR
• To change the remote controller ID to "3": STEREO
„ Firmware Update
Change the settings for Firmware Update.
‰ Update Notice (Default Value: Enable)
Availability of a firmware update is notified via network.
Enable
Notify updates
Disable
Do not notify updates
‰ Version (Default Value: -)
The current firmware version is displayed.
‰ Update via NET (Default Value: -)
Press ENTER to select when updating the firmware via network.
• This setting cannot be selected if you do not have Internet access or there is
no updatable firmware.
‰ Update via USB (Default Value: -)
Press ENTER to select when updating the firmware via USB.
• This setting cannot be selected if a USB storage device is not connected or
there is no updatable firmware in the USB storage device.
• Wait for a while if "Firmware Update" cannot be selected. It can be selected
when the network function is activated.
Setup
155
Advertisement
