Download Print this page

Pioneer Elite VSX-LX805 Instruction Manual page 183

Hide thumbs Also See for Elite VSX-LX805:

Advertisement

between 50 and 100 cm (20" and 40") away to the left and right of the
listening position.
"Full Measurement": Set up the microphone at ear height in the listening
position for measurement. Next, measure in 8 positions to the front, back,
left, right, etc., centered on the listening position. Measure by setting up the
microphone in each of these positions, between 50 and 100 cm (20" and 40")
away from the listening position.
"Quick Measurement"
6. The guidance about outputting the test tone is displayed. Refer to the
illustration to set up the speaker setup microphone in the listening position.
Follow the on-screen instructions to measure.
• Measurement may not be possible if the test tone is to loud or too soft. Tap
"Level Adjust" to adjust the volume of the test tone.
7. When measurement is complete, "Calculating results" is displayed on the
screen. Tap "Transfer to your product" to transfer the measurement data to
the unit.
"Full Measurement"
The illustration shows an image.
8. Disconnect the speaker setup microphone.
• When measurement is performed with Dirac Live, selection in "MCACC Pro"
- "Manual MCACC" ( →p160) and "MCACC Data Check" ( →p165) of the
Home screen is no longer available. Furthermore, the measurement results
are also reflected in "System Setup" - "Speaker" - "Distance" ( →p139) of
the Home screen, and you will no longer be able to change the values. (The
setting units are displayed as "msec".)
Using Dirac Live
You can apply the filter curves adjusted based on the measurement results of
Dirac Live. From "Room EQ" - "Dirac Live" ( →p93) in "AV Adjust", select from
"Slot1" to "Slot3". Note that the same data is saved in all of the slots, but you are
able to create your own original sound quality in the following "Manual Adjust"
section.
• In the Home screen, when the number of speaker channels, etc., is changed
in "System Setup" - "Speaker" - "Configuration" ( →p134), the measurement
results are deleted.
• When using Dirac Live, signals with a sampling frequency of 32 kHz are not
supported.
Setup
183

Advertisement

loading