Advertisement
Playing Back (ZONE 3)
Note
• Analog play of the audio from externally connected AV components is
possible.
• To use Zone 3 speakers, in the Setup menu, set "Speaker" - "Configuration" -
"Zone Speaker" ( →p136) to "Zone 2/Zone 3".
• To use an integrated amplifier, in the System Setup menu, set "Speaker" -
"Configuration" ( →p134) to one of the following:
– Set "Speaker Channels" to "2.1 ch", "3.1 ch", "4.1 ch", or "5.1 ch"
– Set "Speaker Channels" to "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or "5.1.2 ch",
and set "Bi-Amp" and "Zone Speaker" to "No"
• You can only select the same source for the main room and separate room
with the "NET" and "BLUETOOTH" input selectors. Furthermore, if you have
"NET" selected in the main room and you then select "BLUETOOTH" in the
separate room, the main room will also switch to "BLUETOOTH".
• It is not possible to select different stations in the main room and separate
room with AM/FM broadcasts. (North American and Taiwanese models)
• DSD audio signals cannot be output to ZONE 3 with the "NET" input selector.
• If ZONE 3 is on, power consumption during standby will increase.
• This function turns off if you use "Transmitting audio from this unit to
BLUETOOTH wireless technology enabled devices" ( →p86).
Turning ZONE 3 On/Off
1. Face the remote controller at the unit, and while pressing and holding the
ZONE 3 HOLD button on the remote controller, press . On the main unit,
press the ZONE 3 ON/OFF button.
1
"Z3" lights in the main unit display when ZONE 3 turns on. To turn ZONE 3 off,
repeat the same procedure.
• When the power of this unit is switched to standby while using ZONE 3, the
Z3 indicator lights dimly, and the mode switches to play only in the separate
room. Furthermore, the mode switches to play only in the separate room
when this unit is in standby mode and ZONE 3 is turned on.
Playback
2
111
Advertisement
