Advertisement
„ Others
‰ Strange noise can be heard from the unit
• If you have connected another device to the same outlet as this unit, strange noise may occur under the influence of the device. If the symptom
is remedied by removing the power plug of the other device from the outlet, use different outlets for this unit and the device.
‰ The message "Noise Error" appears during Full Auto MCACC
• This can be caused by a malfunction in your speaker unit. Check the speaker output, etc.
‰ The measurement results of Full Auto MCACC show different distances to the speakers from the
actual ones
• Depending on the speakers you are using, some errors may occur in the measurement results. If this is the case, make the settings in "System
Setup" - "Speaker" - "Distance".
‰ The measurement results of Full Auto MCACC show that the volume level of the subwoofer has been
corrected to the lower limit
• The volume level correction of the subwoofer may not have been completed. Lower the volume of the subwoofer before Full Auto MCACC
measurement.
‰ The settings in "Crossover", "Distance", and "Channel Level" are returned to the default values
• When measurements are made with Dirac Live, if you change the settings in "Speaker Channels", "Subwoofer", "Height 1 Speaker", or "Height 2
Speaker" in "Speaker" - "Configuration" ( →p134) in the System Setup menu, then the measurement results are returned to the default values.
Measure again.
Troubleshooting
( →p139)
198
Advertisement
