Table of Contents
Advertisement
2.2
Setting Up the Debugging MCU Board
To apply the debugging MCU board, you must obtain an E10A-USB emulator. This section
describes how to connect the debugging MCU board, the E10A-USB emulator, and the user
system interface board.
Before making the connections, check that the host computer is turned off, the E10A-USB
emulator is not connected to the host computer via the USB cable, and power is being supplied to
neither the debugging MCU board nor the user system.
2.2.1
Connecting the Debugging MCU Board to the E10A-USB Emulator
Follow the below procedure to connect the debugging MCU board to the E10A-USB emulator.
1. Connect the user system interface cable (14 or 36 pins) provided with the E10A-USB emulator
to the side connector of the E10A-USB emulator as shown in figure 2.2.
Figure 2.2 Connecting the E10A-USB Emulator to the User System Interface Cable
18
Advertisement
Table of Contents
