Table of Contents
Advertisement
Mounting
5.3 Installation of UC 100
Positioning the charging station on the base area
To position the charging station on the base area, proceed as follows:
1. Position the charging station on the base area above the holes for the fastening screws.
2. Check that the mounting holes in the feet of the station are above the securing points on the
base area.
3. Lower the charging station onto the base area.
5.3
Installation of UC 100
5.3.1
Inserting the connecting cable into the cabinet
After positioning the charging station on the base area for the first time, insert the power cable
into the charging station cabinet.
Danger to life when standing under lifted loads
If hoisting gear or load handling equipment fail, a lifted load can drop. If you are in the
hazardous area under or next to the lifted load at this time, death, serious injury and material
damage may result.
• Always use hoisting gear and load handling equipment properly.
• Do not stay in the hazardous area under or next to lifted loads.
Danger to life due to improper lifting
If you lift the charging station improperly, the device may tip over. Tipping of the charging
station can cause death, serious injury and material damage.
• Only qualified personnel should lift the charging station.
• Only use approved hoisting gear.
• Pay attention to the center of gravity of the charging station.
• Note the weight of the charging station.
• Only lift the charging station in a vertical position.
• The forks of the forklift must protrude on the opposite side of the charging station.
Securing the charging station in a raised position
To insert the power cable into the cabinet, you need to first lift the charging station and fix it in
a raised position:
1. Drive the fork arms of the forklift underneath the cabinet base.
2. Lift the charging station vertically upwards.
70
WARNING
DANGER
SICHARGE UC 100, UC 200, UC 300, UC 400, UC 600, UC 800
Operating Instructions, 10/2022, A5E50828019-AC
Advertisement
Table of Contents
