Restarting The Charging Process After An Alarm - Siemens SICHARGE UC 100 Operating Instructions Manual

Operating
8.8 Operating the Service menu
8.8.3

Restarting the charging process after an alarm

If the charging station triggers an alarm, the charging station automatically disconnects the
power supply to the charging cable. During the alarm state, the charging station will not charge.
To charge an electric vehicle again, you need to first deactivate the active alarm.
Note
First eliminate the cause of the alarm
When you press the "Acknowledge alarm" button when an alarm is deactivated, the control
system of the charging station checks the cause of the alarm again. While the cause of the alarm
persists, the charging station will not deactivate the alarm.
• First eliminate the cause of the alarm.
• Then deactivate the alarm.
Requirements
• You have opened the Options menu.
• You have pressed the "Alarm" button in the Options menu.
134
SICHARGE UC 100, UC 200, UC 300, UC 400, UC 600, UC 800
Operating Instructions, 10/2022, A5E50828019-AC