Konica Minolta bizhub C658 Service Manual page 1538

bizhub C658/C558/C458/C368/C308/C258
6. ABORT CODE
6.1 Troubleshooting of the abort code (bizhub C368/C308/C258)
• The machine displays an abort code (CF###) on the control panel as it becomes unable to process tasks properly through its software
control.
• When the system program is aborted, check the electrical component, unit, option, and connection relating to the specific type of the abort
condition.
6.1.1 Contents
Trouble type Abort code
Trouble code CF001 to CFFE0
Rank C
Trouble detection condition -
Trouble isolation -
Relevant electrical parts
6.1.2 Procedure
• When an abort code occurs, take a check and action in the following procedure.
Step Section
1 Main power Turn OFF and ON the main power switch, and check if
switch the Abort code appears again.
2 Connector Check the connector for proper connection and correct
connection as necessary.
3 Firmware Update the firmware to the latest version, and check if
the Abort code appears again.
4 Memory Check Execute [Service Mode] -> [State Confirmation] ->
[Memory/Storage Adjustment] -> [Memory Check] ->
[Rough Check], and check that no abnormalities.
5 Storage R/W Execute [Service Mode] -> [State Confirmation] ->
Check [Memory/Storage Adjustment] -> [Storage R/W Check],
and check that no abnormalities.
6 MFP board Replace the MFP board (MFPB), and then check the
MFPB.
6.2 Troubleshooting of the abort code (bizhub C658/C558/C458)
• The machine displays an abort code (CF###) on the control panel as it becomes unable to process tasks properly through its software
control.
• When the system program is aborted, check the electrical component, unit, option, and connection relating to the specific type of the abort
condition.
6.2.1 Contents
Trouble type Abort code
Trouble code CF001 to CFFB5
Rank C
Trouble detection condition -
Trouble isolation -
Relevant electrical parts
• MFP board (MFPB)
• Memory board (MEMB: UK-211)
• EFI relay board (VI-508)
• Dual scan image processing board (DSIPB: DF-704)
• Hard disk (A) (HDD (A))
• Hard disk (B) (HDD (B): HD-524)
Check Item
• MFP board (MFPB)
• Memory board (MEMB: UK-211, Expansion
memory)
• EFI relay board (VI-508)
• Dual scan image processing board (DSIPB:
DF-704)
• Hard disk (A) (HDD (A))
• Hard disk (B) (HDD (B): HD-524)
• MFP board (MFPB)
Resul
t
NO When not reappearing, continuous use is carried
out, and it is checked whether an abort code
occurs.
NO It will correct, if connector connection has
abnormalities.
NO Select [Service Mode] ->
make sure that the firmware has been updated to
the correct version.
NO When "NG" is displayed, replace the appropriate
memory or PWB.
• WORK0: Standard memory (MFPB)
• WORK1: Memory board (MEMB: UK-211)
• FILE0,1: MFP board (MFPB)
• FILE2,3: EFI relay board (VI-508)
• FILE4,5: Dual scan image processing board
NO When "NG" is displayed, replace the hard disk
(HDD).
NO Other electric parts indicated to Component of
abort code list are replaced.
K-210
K TROUBLESHOOTING > 6. ABORT CODE
Action
[Firmware
(DSIPB: DF-704)
Version] and