Konica Minolta bizhub C658 Service Manual page 1842

bizhub C658/C558/C458/C368/C308/C258
[1] Waste toner box detection plate
(1) Execution timing
The waste toner box detection control is performed under any of the following conditions:
• "The power switch is turned ON"
• "The front door or right door is closed"
(2) Waste toner box yet-to-be-mounted display
9.3.4 Waste toner box full detection
• The waste toner full sensor provided on the front side board is used to determine the amount of waste toner accumulated in the waste toner
box.
NOTE
▪ For the life of the waste toner box, refer to
Consumable/part replacement time (bizhub
(1) Waste toner near-full
• The toner collecting screw provided in the waste toner box conveys waste toner in the box onto the central portion of the box. For details,
see " O.9.3.2 Control of waste toner conveyance through waste toner
• A detection window for detecting a waste toner full condition is equipped at the central portion of the waste toner box. When the waste
toner conveyed onto the central portion of the box exceeds a predetermined height, waste toner spills over the waste toner full condition
detection section.
• The machine determines that there is a waste toner near-full condition, if the waste toner full sensor is blocked by the waste toner
stagnant over the waste toner full condition detection section for a predetermined period of time or longer.
(a) Execution timing
The waste toner box near-full detection control is performed under any of the following conditions:
• "The machine determines that the waste toner box is mounted in place using the waste toner box set sensor."
• "During a print cycle"
• "During execution of image stabilization control"
O THEORY OF OPERATION bizhub C658/C558/C458/C368/C308/C258 > 9. TONER
[1]
-
F.6.1 Consumable/part replacement time (bizhub C368/C308/C258)
C658/C558/C458).
box".
O-67
-
COLLECTING SECTION
and F.6.2