Table of Contents
Advertisement
85DR2-DC / 85DR2-DCL
2-3 Memory Installation
How to tackle the memory modules:
• Make sure to unplug your power supply before adding or removing
memory module. Failure to do so may cause severe damage to both your
mainboard and the memory module.
• Pay attention to the orientation of the DIMM slots. Forcing a DIMM into a
slot improperly will damage the memory module and the slot itself.
• Make sure you have the right type of memory module for your mainboard.
2-3.1 To Install DIMM Module
• This series only supports up to 2GB unbuffered DDR 266/200MHz
SDRAM, with 2 DDR DIMM slots on board. Do not insert other type of
memory module into these slots.
• DDR DIMM slot has 184-pins and one notch. Insert a DDR SDRAM
vertically into the 184-pin slot with the notch-to-rib matching. Press the
module down in a gradual way until it surely reaches the bottom and
clicks straight up the two latches on the left and right of the slot. If any
one of the latches has not turned up completely, you should unplug the
module and press it down the slot a bit more firmly.
(2.5V Voltage Key)DDR Notch
2-3.2 To Remove a DIMM:
• Press down the holding latches on both sides of the DIMM slot and the
module will be released from it.
184-Pin DIMM Notch Key Definitions
DRAM Key Position
Voltage Key Position
Module Latch
DDR Rib
20
Advertisement
Table of Contents
