Table of Contents
Advertisement
Series 85DR2: 85DR2, 85DR2-L, 85DR2
5-2.5-2 Installing Drivers With Existing Windows NT4.0
W A R N I N G :
W A R N I N G :
Your must first complete installing the driver before
moving the boot drive containing the existing Windows NT operating
system on to the FastTrak133-Lite controller (e.g. IDE3/IDE4). On
this series, IDE1/0 are for system IDE controller, while IDE3 & IDE4
are for RAID IDE controller.
With your bootable hare drive connected to IDE1/IDE2 and FastTrak133-
Lite enabled by JP17, boot Win NT4.0.
1. Choose "Settings" from the "Start" menu.
2. Choose "Controller Panel" from the "Settings" menu.
3. Double-click on the "SCSI Adapters" icon, which generates the
"SCSI Adapters" dialog box.
4. Choose "Drivers," and then press "Add."
5. In the "Install Drivers" dialog box, press "Have Disk..."
6. When the "Install From Disk" appears, insert into Drive A the "FastTrak133-
Lite Driver" diskette that you have made from support CD:.
7. Type "A:\NT4" in the text box window, then choose "OK."
8. When the "Install Driver" dialog box appears, select " Win NT Prom
ise FastTrak133-Lite controller" and then press "OK."
9. When the "Select SCSI Adapter Option" dialog box appears, press "Install".
10. After a successful installation, the "SCSI Adapter Setup" box will show
that the "Win NT Promise FastTrak133-Lite (tm) Controller" driver has
been installed.
11. Power off your system.
12. Now you can move the boot drive to the FastTrak133-LiteController.
+
, 85DR2
+
-L
104
Advertisement
Table of Contents
