SL-865G3 / 865G3-L
2-2 Memory Installation
How to tackle the memory Modules:
• Make sure to unplug your power supply before adding or removing
memory module.
• Pay attention to the orientation of the DIMM slots.
2-2.1 To Install DDR SDRAM Module
• To enable Dual-channel memory function, users should insert totally
identical (size and frequency) DDR module pair into the bank-pair. In
this series, DIMM1 and DIMM3 is a pair, and DIMM2 and DIMM4 is
another.
• DDR DIMM slot has 184 pins and one notch. Insert a DDR SDRAM
vertically into the 184-pin slot with the notch-to-rib matching.
2-2.2 Dual Channel Memory Features
The Dual Channel DDR SDRAM installation is quite different from the
Single channel installation.
• Dual Channel memory configuration provides higher performance than
Single Channel configurations
• Matched DIMMs need to have identical density, DRAM technology,
DRAM bus width, and equal number of memory banks.
• This series supports up to 4GB unbuffered Dual-channel DDR 400/
333/266 SDRAM, with 4 DDR DIMM slots on board. Do not insert
other type of modules into these slots.
• The dual memory controller can double the DDR memory bandwidth
up to 6.4GB/s with DDR400, 5.4GB/s with DDR333 and 4.2GB/s with
DDR266.
184-Pin DIMM Notch
DRAM Key Position
(2.5V Voltage Key)
D I M M 1
Bank
DIMM3
DIMM1+DIMM3 = (with identical pair) Dual
DIMM2+DIMM4 = (with identical pair)
Chapter 2 Hardware Setup
Voltage Key Position
DDR
Module
13
DIMM2
Bank
DIMM4