Table of Contents
Advertisement
SL-K8T-939FL
2-2 Memory Installation
2-2.1 To Install DDR SDRAM Module
• Make sure to unplug your Power Supply before adding or removing
memory module. Failure to do so may cause severe damage to both
your mainboard and the memory module.
• Pay attention to the orientation of the DIMM slots. Forcing a DIMM in
a socket improperly will damage the memory module and slot.
• Make sure you have the right type of memory module for your
mainboard.
2-2.2 Dual Channel Memory Features
• Dual Channel Memory Configuration is formed by couple of identical
DDR SDRAMs.
• Matched DIMMs need to have identical density, DRAM technology,
DRAM bus width, and equal number of memory banks.
• This series supports up to 4GB unbuffered Dual Channel DDR 400/
333/266 SDRAM, with 4 DDR DIMM slots on board. Do not insert
other type of modules into these slots.
• The dual memory controller can double the DDR memory bandwidth
up to 6.4GB/s with DDR400, 5.4GB/s with DDR333 and 4.2GB/s with
DDR266.
(2.5V Voltage Key) DDR Notch
DIMM1
Bank A
DIMM2
To Boot PC with Dual Channel Memory Configuration
Populate Bank A / Bank B / Bank A+Bank B with identical DIMMs
To Boot PC with Single Channel Memory Configuration
Populate DIMM1 / DIMM3 / DIMM1 + DIMM3 with identical DIMMs
(Note: DIMM2 / DIMM4 / DIMM2 + DIMM4 cannot boot PC.)
184-Pin DIMM Notch Key Definition
DRAM Key Position
Module Latch
Chapter 2 Hardware Setup
Voltage Key Position
Slot Rib
16
DIMM3
Bank B
DIMM4
Advertisement
Table of Contents
