Other Connectors Configuration; 2-9.1 On Board Fan Connectors - SOLTEK 85DR2-DC Manual

2-9 Other Connectors Configuration

This section lists out all connectors configurations for users' reference.

2-9.1 On Board Fan Connectors

PS/2 Mouse
JKB1
(on top)
PS/2 K/B (underside)
RJ45
(on top)
USB0 (middle)
USB1 (underside)
RT1
1
Intel
CN9
i845E
JFSB1
JFSB2
JP3
RTL
AC'97
ALC650
Codec
PCI 1
LED1
PCI 2
PCI 3
JP9
PCI 4
LPC I/O
W83627HF
PCI 5
Audio1
14
WOL1
USB2
1
Both Sensor and No-sensor Fan Connectors support CPU/AGP/Sys-
tem/Case cooling fan with +12V mode. When connecting the wire to
any Fan Connector, users should make sure that the red wire is for the
positive current and should be connected to pin +12V, and the black
wire is Ground and should be connected to pin GND.
A Hardware Monitor chipset is on board, with which users can install
a Hardware Monitor Utility and read the fan speed transmitted from the
sensor fan. Otherwise, users can read the fan speed from the "Hard-
ware Monitor Status" in CMOS BIOS.
A running Fan will send out 2 electric pulses per rotation of its fan
blade. A Sensor Fan Connector will count the electric pulses and send
the information to the System Hardware Monitor which in turn will work
out the fan rotation speed and display it on screen.
+12V Power
ATX
POWER
1
LED2
AGP 4X
Intel
ICH4
JBAT1
BIOS
Fan3
USB3
HDD LED IR PWR
-
+
20
Jp11
1
NJ1
-
+
1 1
SPK RST PWLED
31
Chapter 2 Hardware Setup
Sensor
+12V
+12V
GND
GND
Sensor Conn.
No Sensor
Fan Connector
Fan2, yellow, sensor
Fan Connector
Fan1, yellow, sensor
Fan Connector
Fan3, white, no sensor
Void