Table of Contents
Advertisement
85DIR
2-3 Memory Installation
How to tackle with the memory Modules:
• Make sure to unplug your power supply before adding or removing memory
module. Failure to do so may cause severe damage to both your mainboard
and the memory module.
• Pay attention to the orientation of the DIMM slots. Forcing a DIMM in a
socket improperly will damage the memory module and socket.
• Make sure you have the right type of memory module for your mainboard.
2-3.1 To Install DIMM Module
• This series of mainboards only supports up to 2GB unbuffered DDR
SDRAM, with 2 DDR DIMM sockets on board. Do not insert other type of
modules into these sockets.
• DDR DIMM socket has 184-pins and one notch. Insert a DDR SDRAM
vertically into the 184-pin socket with the notch matching the one in the
socket. Press the Module down in a gradual way until it surely reaches
the bottom and clicks straight up the two latches on the left and right of
the socket.
Key Point: Press the module down gradually until it has totally
reached the socket bottom and clicked up both two socket latches
completely. If any one of the latches has not turned up completely,
you should unplug the module and press it down the socket a bit
more firmly.
2-3.2 To Remove a DIMM:
• Press down the holding latches on both sides of socket and the module
will be released from the DIMM socket.
184-Pin DIMM Notch Key Definitions(2.5V)
DRAM Key Position
Voltage Key Position
2.5V
18
Advertisement
Table of Contents
