Table of Contents
Advertisement
5-2.2 Windows 95/98
The following three sections detail the installation of the FastTrak133-Lite
drivers while installing Windows 95/98. If you're installing the Fast-
Trak133-Lite drivers on a system with Windows 95/98 already installed,
see "Installing Drivers with Existing Windows 95/98".
5-2.2-1 Installing Drivers During Windows 98 Installation
1. Connect your hard drive(s) for RAID Array to IDE3/IDE4, and en-
able FastTrak133-Lite Controller with JP17. Configure the hard drive
(s), partition and format your hard driver(s).
2. Install Windows 98 normally.
3. After installation, go to "Start" menu and choose "Settings."
4. Form the "Settings" menu, choose "Control Panel."
5. In the "Controller Panel" window, double-click on the "System" icon.
6. In the "System" window, choose the "Device Manager" tab.
7. In the hierarchical display under "Other Devices" is a listing for "PCI
RAID Controller." Choose it and then press the "Properties" button.
8. Choose the "Driver" tab in the "Properties" window, choose "Update
Driver," and then press "Next."
9. Choose "Search for a better driver than the one your device is using
now (recommended), "then press "Next".
10. Choose "Specify Location," and then type "A:\WIN95-98" in the text box.
11. Insert the "FastTrak133-Lite Driver" diskette into the A: drive.
12. Press the "Next" button. A message informing you that Windows 98
has found "Win95-98 Promise FastTrak133-Lite (tm) Controller"
should appear.
13. Press "Next," then "Finish," then "Yes" when asked if you want to restart
your computer. Be sure to remove the diskette from drive A:.
Chapter 5 RAID Controller
99
Advertisement
Table of Contents
