SOLTEK 85DR2-DC Manual page 91

Series 85DR2: 85DR2, 85DR2-L, 85DR2
5-2.1-2 Installing Driver To Existing Windows 2000/XP
System
W A R N I N G :
W A R N I N G :
moving the boot drive containing the existing Windows 2000 operating
system on to the FastTrak133-Lite controller (e.g. IDE3/IDE4). On
this series, IDE1/0 are for system IDE controller, while IDE3 & IDE4
are for RAID IDE controller.
At booting with Windows 2000/XP system with Jp17 enabled, and your
hard drive(s) connected to IDE1/2, Windows 2000/XP setup will show a
"New Hardware Found" dialog box. Under Windows 2000, the "PCI RAID
Controller" will be displayed.
1. In the dialog box, choose "Driver from disk provided by hardware manu-
facturer " button.
2. In the A: drive, insert the FastTrak133-Lite driver diskette.
3. Type "A:\WIN2000" in the text box. Press "Enter".
4. Choose "Win2000 Promise FastTrak133-Lite Controller" from the
list that appears on screen, then press the "Enter" key.
5. The Windows 2000 setup screen will appear again saying "Setup will
load support for the following mass storage device - Win2000 Promise
FastTrak133-Lite controller. The FastTrak133-Lite driver will now be
copied on to the system and entered into the Windows 2000 driver
database.
6. When the "System Setting Change" dialog box appears, remove
the floppy diskette and click on "Yes" to restart the system. Win-
dows 2000 will then restart for the driver installation to take effect.
7. Power off your system, then connect your hard drive to the FastTrak
IDE3/IDE4 for Disk Array setup.
5-2.1-3 Confirming Windows 2000 Installation
1. From Windows 2000, open the Control Panel from " My Computer"
followed by the System icon.
2. Choose the "Hardware" tab, then click the "Device Manager" tab.
3. Click the "+" in front of "SCSI & RAID Controllers hardware type." The
driver "Win2000 Promise FastTrak/FastTrak133-Lite Controller" should
appear, informing user that the controller driver is already installed.
Your must first complete installing the driver before
98
+ , 85DR2 + -L