Memory Installation; 2-2.1 To Install Ddr Sdram Module; 2-2.2 To Remove A Dimm - SOLTEK NV400-64 Manual

2-2 Memory Installation

How to tackle the memory Modules:
• Make sure to unplug your power supply before adding or removing
memory module. Failure to do so may cause severe damage to both
your mainboard and the memory module.
• Pay attention to the orientation of the DIMM slots. Forcing a DIMM
into a slot improperly will damage the memory module and slot itself.
• Make sure you have the right type of memory module for your
mainboard.

2-2.1 To Install DDR SDRAM Module

• This series supports up to 2GB unbuffered DDR 400/333/266 SDRAM,
with 2 DDR DIMM slots on board. Do not insert other type of mod-
ules into these slots.
• DDR DIMM slot has 184-pins and one notch. Insert a DDR SDRAM
vertically into the 184-pin slot with the notch-to-rib matchingPress
the module down in a gradual way until it surely reaches the bottom
and clicks straight up the two latches on the left and right of the slot.
If any one of the latches has not turned up completely, you should
unplug the module and press it down the slot a bit more firmly.
DRAM Key Position
(2.5V Voltage Key)DDR Notch

2-2.2 To Remove a DIMM

Press down the holding latches on both sides of slot to release the
module from the DIMM slot.
184-Pin DIMM Notch Key Definitions
Voltage Key Position
Module Latch
Chapter 2 Hardware Setup
DDR Rib
19