Memory Installation; 2-2.1 To Install Ddr Dram Module; 2-2.2 To Remove A Dimm - SOLTEK KT333A Manual

2-2 Memory Installation

How to tackle the memory Modules:
• Make sure to unplug your power supply before adding or removing
memory module. Failure to do so may cause severe damage to both
your mainboard and the memory module.
• Pay attention to the orientation of the DIMM slots. Forcing a DIMM
into a slot improperly will damage the memory module and slot itself.
• Make sure you have the right type of memory module for your
mainboard.

2-2.1 To Install DDR DRAM Module

• This series supports up to 3GB unbuffered DDR 266/333 SDRAM,
with 3 DDR DIMM slots on board. Do not insert other type of mod-
ules into these slots.
• DDR DIMM slot has 184-pins and one notch. Insert a DDR DRAM
vertically into the 184-pin slot with the notch-to-rib matching. Press
the module down in a gradual way until it surely reaches the bottom
and clicks straight up the two latches on the left and right of the slot.
If any of the latches has not turned up completely, you should unplug
the module and press it down a bit more firmly.
184-Pin DIMM Notch Key Definitions (2.5V)
DRAM Key Position

2-2.2 To Remove a DIMM

Press down the holding latches on both sides of slot to release the
module from the DIMM slot.
Voltage Key Position
2.5V
DDR Notch
Module Latch
19
Chapter 2 Hardware Setup
DDR Rib