Table of Contents
Advertisement
3-6 To Install LAN Drivers (for 85DR2-DCL only)
3-6.1 RTL8100B LAN driver on Windows ME / 2000 / XP
1. When you newly install Windows ME, Windows 2000 or Windows
XP, the system will detect the LAN Controller on board and
configure it automatically into system. Therefore, users need not
bother to install the LAN controller into these operating systems.
2. To verify the existence of RTL8100B Controller and Driver, please
enter the "Control Panel" of your system and click "Network" to
open the "Configuration" screen. You can then see the
"Realtek8139 (A/B/C) PCI Fast Ethernet Adapter" is already
installed in system.
3-6.2 RTL8100B LAN driver on Windows 9X
The LAN driver contained in the Support CD is not included in the
Autorun Menu. To install RTL8100B LAN driver on Windows 9X,
please follow the steps shown below:
1. On the "Start" screen of your system, please click to the following
path:
\My Computer\properties\Device manager
2. In the "Device manager" screen, you can see the item " PCI
Ethernet Controller" with a yellow question mark on its left side,
which indicates that the LAN controller is already detected by
system but the driver for this on-board RTL8100B Ethernet
Controller is not installed yet. Please point to this item with your
mouse and double click on it (or click the "Properties" button).
3. Instantly, the "PCI Ethernet Controller Properties" screen shows
up. Please click the "General" bar to continue.
4. In the "General" screen, click "reinstall Driver" button to continue.
Please note that the status of "Device Usage" should stay at
"Exists in all hardware profiles".
Chapter 3 Software Setup
Click Here
51
Advertisement
Table of Contents
