SOLTEK 85DR2-DC Manual page 90

5-2 Installing Drivers
This section details the FastTrak133-Lite driver installation for various op-
erating systems. The driver should have been included either into the
Support CD or into a Support Floppy Diskette.
Checkpoints for the driver installation:
1. To install FastTrak133-Lite Driver for an operating system, you must
use the driver in Floppy Diskette instead of the one in CD. If you are
not provided with a Driver Diskette, you should create one by copy-
ing the driver files through the support CD with the path:
"E \Driver\Promise\FastTrak133-Lite. (Suppose that CD-ROM title is E).
2. Set JP17 on board enabled (Pin 1-2 closed) for RAID Controller Select.
The following sections describe the detailed procedures of installing
FastTrak133-Lite Driver for windows 2000/XP, Windows 95/98, Win-
dows NT4.0, and Windows 3.1 / DOS.
5-2.1 For Windows 2000 / Windows XP
5-2.1-1 Installing Driver During New Windows 2000 / XP
Installation
1. Connect your hard driver(s) for RAID Array to IDE3/IDE4, and enable
FastTrak133-Lite Controller with JP17.
Boot from the windows 2000 CD. Press <F6> after the message " Press
F6 if you need to install third party SCSI or RAID driver" appears.
2. Then, the "Windows 2000/XP Setup" starts to load files from CD-
ROM until it asks for "Specify Additional Device". Press "S" to Specify
an Additional Device.
3. Then, "Windows 2000/XP Setup will ask for the hardware support disk,
that is, the Promise RAID Driver. Insert into drive A the Support Floppy
Disk containing the Promise FastTrak133 Lite RAID Controller Driver
and then press "Enter" to continue.
4. Next, choose "Win2000/XP Promise MBFastTrak133-Lite Control-
ler" from the list that appears on screen, then press the "Enter" key.
5. The Windows 2000/XP Setup screen will appear again saying "Setup
will load support for the following mass storage devices:" The list will in-
clude "Win2000 Promise FastTrak133-Lite controller".
Note:
If you need to specify any additional devices to be installed, do
so at this time. Once all devices are specified, continue to step 7.
6. From the Windows 2000/XP Setup screen, press the Enter key. Setup
will now load all device files and then continue the installation.
Chapter 5 RAID Controller
97