Table of Contents
Advertisement
85DIR3 / 85DIR3-L
2-3 Memory Installation
How to tackle the memory Modules:
• Make sure to unplug your power supply before adding or removing
memory module. Failure to do so may cause severe damage to both
your mainboard and the memory module.
• Pay attention to the orientation of the DIMM slots. Forcing a DIMM
into a slot improperly will damage the memory module and slot itself.
• Make sure you have the right type of memory module for your
mainboard.
2-3.1 To Install DDR DRAM Module for this Mainboard
• This Mainboard only supports up to 2GB unbuffered DDR 333/266/
200 DRAM, with 2 DDR DIMM slots on board. Do not insert other
type of modules into these slots.
• DDR DIMM slot has 184-pins and one notch. Insert a DDR DRAM
vertically into the 184-pin slot with the notch-to-rib matching. Press
the Module down in a gradual way until it surely reaches the bottom
and clicks straight up the two latches on the left and right of the slot.
If any one of the latches has not turned up completely, you should
unplug the module and press it down a bit more firmly.
DRAM Key Position
184-Pin DIMM Notch Key Definitions (2.5V)
Voltage Key Position
2.5V
2.5V
DDR Notch
Module Latch
DDR Rib
20
Advertisement
Table of Contents
