Table of Contents
Advertisement
SL-XP865G-3IG
2-3 Memory Installation
2-3.1 To Install DDR SDRAM Module
• Make sure to unplug your power supply before adding or removing
memory module.
• Pay attention to the orientation of the DIMM slots.
• DDR DIMM slot has 184 pins and one notch. Insert a DDR SDRAM
vertically into the 184-pin slot with the notch-to-rib matching.
(2.5V Voltage Key)DDR Notch
DIMM1
DIMM2
2-3.2 Dual Channel Memory Modules Setup
• To enable Dual Channel memory function, users should insert totally
identical (size and frequency) DDR module pair into the bank-pair.
• Dual Channel memory configuration provides higher performance than
Single Channel configurations
• Matched DIMMs need to have identical density, DRAM technology,
DRAM bus width, and equal number of memory banks.
• This series supports up to 2GB unbuffered Dual-channel DDR 400/
333/266 SDRAM, with 2 DDR DIMM slots on board. Do not insert
other type of modules into these slots.
• The dual memory controller can double the DDR memory bandwidth
up to 6.4GB/s with DDR400, 5.4GB/s with DDR333 and 4.2GB/s with
DDR266.
184-Pin DIMM Notch Key Definition
184-Pin DIMM Notch Key Definitions
DRAM Key Position
Voltage Key Position
Module Latch
DIMM1+DIMM2 = Dual Channel Memory
DDR Rib
20
Advertisement
Table of Contents
