Table of Contents
Advertisement
Saia-Burgess Controls AG
6.2
Reset / Device Back to default parameters
The reset button from previous chapter 6.0 can also be used in some special cases
to make a full reset of the MB-Panel and to restore the default parameters set from
the manufacturer.
When can this function be useful?
When doing a FTP connection to the local server, it can be that you did copy in wrong
directory the local file desired. Or may be you did erase inadvertently some files
needed for the Setup Menu display.
The most known Error is when the display is writing :
the screen stays for a while without changing the page displayed.
In that case do the following steps:
1. Power off the MB-Panel
2. On the Top of the Back Cover, activate the reset button (see previoused chapter )
by holding it
3. At the same time, power on the MB-Panel. After about 5 seconds, the buzzer is
switched on and its frequency is increasing.
4. Once the sound (resp. frequency) of the buzzer is stabilized, after about 10 sec-
onds, you can release the reset button and wait.
The waiting time can last between 1 or 2 minutes. In that time the FW does rebuild
the whole memory organization and recover every necessary default files.
At the end the MB-Panel will do an
Touchscreen
The position of that
6.3
Contrast Adjustment
Our LCDs Supplier have some Tolerance due to a Visual quality check in their
Manufacturing due also to the temperature. Added to that the different component's
tolerance plays also a role.
Even that, the pixels brightness is directly dependent from the temperature.
Therefore, actually, it is better to adjust the contrast settings manually once the panel
is working at its most frequent temperature.
Especially on the Black&White Panel where no automatic temperature adjustment is
actually done, the user must be aware.
Manual PCD7.D4xx │ D ocument 26-851 ENG12 │ 2 016-02-05
automatic reboot
calibration. Calibrate it and your system will be fully restored.
reset button
is shown in the chapter «Firmware Update» above.
Update & special settings
Reset | Contrast Adjustment
«uBTerminal not found»
and ask you for a
new
and
6
6-4
Advertisement
Table of Contents
