SBC PCD7.D4 Series Manual page 74

Saia-Burgess Controls AG
If the connection is not written USB in PGU/Auto mode, go in menu File/online
settings and adjust the connection to USB port as follow:
Update von Booter file:
Please only use our «Installer Package» as this operation is not common
The best way to make the FW Download is to :
1. Start your FW download tool and configure it, as explained.
2. Power on the MB-Panel, with the USB cable REMOVED
3. Once the Panel is powered, you'll see a bar named «Enter in Setup Menu».
Activate it by pressing on the Touchscreen or with the Enter Button.
4. Go in the Setup Menu System/Download FW and press OK !
5. The green LED must flash at a regular frequency of about 3 flashs per sec.
6. NOW you are able to connect the USB Cable on the MB-Panel and to press Start
on the FW Dowload tool.
REMARK:
If you stop or loose the communication during that procedure, the system won't show
you again any display. It is then normal because the FW Flash Memory is erased at
the beginning of the procedure. Please retry the same steps without this time chap-
ters 3 and 4.
Manual PCD7.D4xx │ D ocument 26-851 ENG12 │ 2 016-02-05
Update & special settings
Firmware Update
6
6-2