Table of Contents
Advertisement
Saia-Burgess Controls AG
3
Communication mode setting
3.1
Http direct – Baudrate and Controls
On this communication port, there is an autonegociation mode between the MB-Pan-
el and the Ethernet switch or the PLC directly attached to. This mode will defined him-
self the speed rate 10 Mbps or 100 Mbps. For sure the max speed rate at 100 Mbps
is better.
3.2
Ether-S-Bus – Baudrate and Controls
On this communication port, there is an autonegociation mode between the MB-Panel
and the Ethernet switch or the PLC directly attached to. Exactly the same as defined
for previoused http direct.
But here the frame streaming is slower than http because it is based on S-Bus
frames. These frames are automatically defined and the user has no possibility to
change them.
The only
parameters
Communication/Ether S-Bus Options-Configure:
■ the timeout in ms to get an answer from the station connected to and
■ the number of retries to be connected
Otherwise here below an example of the setup page S-Bus Connection Settings
when Ether S-Bus is needed (example of S-Bus connection settings with QVGA MB-
Panels):
Manual PCD7.D4xx │ D ocument 26-851 ENG12 │ 2 016-02-05
adjustable are accessible under the Setup Menu/Configuration/
Communication mode settings
Baudrate and Controls - Http direct | Ether S-Bus
3
3-1
Advertisement
Table of Contents
