Table of Contents
Advertisement
Saia-Burgess Controls AG
If the green LED doesn't light as described, then do the following added step:
A. Power off the MB-Panel
B. O n the Top of the Back Cover there is a hole of 3 mm diameter. Inside you'll find a
button. Take a fine pen or a little screwdriver and press continously (hold it) on that
button. Here below the position of that
C. T hen at the same time Power ON the MB-Panel. Wait about 3-4 sec. until the LED
is flashing. Then go back to upper chapter 5.
ATTENTION: the named *blk file corresponds to a full FW file. Use only files provided
by Saia Burgess Controls and for a Panel PCD7.D4xx.
Downgrade to old FW version:
A downgrade to an old version can be done. The download of the FW Booter is not
required. For this operation, either use the Installer provided (if existing) or just load
the FW file (ex. uBT_V1002_SBC.blk) you need. If you are not sure about this
operation please contact our Support Call Center.
Manual PCD7.D4xx │ D ocument 26-851 ENG12 │ 2 016-02-05
reset
reset button
Update & special settings
button:
Firmware Update
6
6-3
Advertisement
Table of Contents
