S-Bus Connection - SBC PCD7.D4 Series Manual

Saia-Burgess Controls AG
4.2.7

S-Bus Connection

This page lets you defining 16 S-Bus different S-Bus connections resp. stations
1 S-Bus name
2 S-Bus communication status
3

If the connection doesn't work, here below some
■ Bad cabling. Most current error.
■ Bad grounding. Can cause damage to the interface !
■ Connection to the wrong serial line.
■ Incompatible transmission speed.
■ Slave station not assigned.
■ Slave station not started.
■ Slave address mismatch.
■ Defective interface (sender and/or receiver).
■ The Saia PCD firmware does not support this mode
Manual PCD7.D4xx │ D ocument 26-851 ENG12 │ 2 016-02-05
Setup Menu Configuration "step by step"
Default: none Entering all connection setting of each station:
Default: none Status of communication
 = communication OK
– = communication error
Back to communication menu
potential sources of errors
Setup Menu QVGA MB-Panels
4
:
4-17