System Special (Advanced And Haptic) - SBC PCD7.D4 Series Manual

Saia-Burgess Controls AG
5.9.2

System Special (advanced and haptic)

1 Reset all parameters
2 Format M1_FLASH file
system
3 Format INTFLASH file
system
4 System
5.9.2.1 Haptic version (PCD7.D457VTCFH)
1 Haptic On/off
2 Mouse Down Effect
3 Mouse Up Effect
4 System settings
The haptic-enabled HMI device will come with a library of haptic effects. Which effect
is denoted by a numeric value, starting from 1. The total number of effects available
has not been defined and will vary for different hardware. The effects index described
here will be exposed by the firmware to the Microbrowser/Web Editor. The firmware
will be responsible for managing the effects library, such that the haptic effect for
each number remains consistent over different hardware versions.
Manual PCD7.D4xx │ D ocument 26-851 ENG12 │ 2 016-02-05
 Only for Haptic MB panel VTCFH
Warning! S-Bus on Port 0 will not work if haptic is
enabled - see the section 5.9.2.1
This command allows to reset all parameters to the default values
Advanced function with this message of confirmation: «Do you really
want to format the M1 flash?» This command erases flash and creates
files system. When format is Ok. Return to the sytem menu (see 4)
Advanced function with this message of confirmation: «Do you really
want to format Intflash?» Be carefull you lose all the parameters of
configuration, S-Bus and MBterminal, Including the calibration. The
panel reboots automatically.
Return to the system menu
Default: On Change by pressing once
Default: 8
Mouse down effect  number 1 to 27, which are
configured globally and apply to the buttons only
Default: 2 Mouse Up effect  number 1 to 27, which are con-
figured globally and apply to the buttons only
Return to system settings page
Setup Menu VGA MB-Panels
Order of file search
5
5-13