Communication; Http Direct Over Ethernet Rj-45 Connector - SBC PCD7.D4 Series Manual

Saia-Burgess Controls AG
1.7

Communication

1.7.1

HTTP direct over Ethernet RJ-45 connector

The quickest communication port is actually the Ethernet port through RJ-45 where
the protocol http direct is selected. The speed is either 10 M or 100 Mbit/s after an
auto-negociation protocol with the connected device. Our MB-Panel can be used on a
network Ethernet through any switch box or router.
This http connection can only be made between our PCD7.D4xx and any
PCD3.M3xxx or PCD3.M5xxxx where an Ethernet connection exists:
Quick test?
■ At the beginning the Saia PCD used must have a Web program loaded in it, cre-
ated with the Web-Editor (see manual 26-838_Manual_Web-Editor). Some exam-
ples can be asked to our SBC Support Team or soon available on our Internet site.
■ Using a Standard
PCD7.D4xx (from block X2) to the Saia PCD device like PCD3.Mxxx series where
the Ethernet communication connector is present.
■ Using a PCD3.Mxxx PLC, define the HW settings of the Saia PCD
S-Bus support must be selected together with the TCP/IP Channel where a valid
IP Address is entered.
Setup adjustment of MB-Panel:
Configure the MB-Panel entering in the Setup Menu
At first be sure you are on the same network

has an IP Address 192.168.12.92, give an IP Address to your terminal (in the
menu Network) like 192.168.12.90 as normally the default subnet mask is set to
255.255.255.0
Second, in the configuration Menu, enter the Address of the start page

responds to the Saia PCD IP Address, and also enter its html start page name.
Now your MB-Panel should be connected to the Saia PCD and the start page selec-
ted should be displayed on the screen. You can now navigate in your Web-pages !
Manual PCD7.D4xx │ D ocument 26-851 ENG12 │ 2 016-02-05
Ethernet http direct
CAT5 cross cable
or equally you can connect your terminal
(refer to chapters 5 and 6):
subnet. For ex. if the Saia PCD
Quickstart
Communication
device :
that cor-
1-6
1