Table of Contents
Advertisement
Saia-Burgess Controls AG
1.7.5
Ether-S-Bus Communication on Ethernet Port
Depending on the application you set up, you may like to use the Protocol Ether-S-
Bus together with a PLC (see HW system overview for Saia PCD type allowed)
This Ether-S-Bus connection is foreseen to be used between our PCD7.D4xx and
PCD3.M3/M5, PCD1.M135+F650, PCD2.M150/M170+F650 or PCD2.M480/7+F650
where «less fast» communication is acceptable. The speed is about the same as
standard S-BUS communication.
This communication is using the Ethernet port X2 where the S-Bus frames are sent
over. The speed is here limited to the time taken by the S-Bus frame sent, and is
therefore not adjustable.
Quick test?
■ At the beginning the Saia PCD used must have a Web program loaded in it cre-
ated with the Web-Editor (help yourself with the 26-838_Manual_Web-Editor)
■ Using a Standard
PCD7.D4xx from block X2 to the Saia PCD as ex. PCD2.M480+PCD7.F650 on the
RJ-45 Ethernet connection.
Using a PCD2.M480 side, define the HW settings of the Saia PCD
■
S-Bus support and station must be selected together with the TCP/IP Channel
where a valid IP Address (same subnet) is entered.
Setup adjustment:
Configure the MB-Panel entering in the Setup Menu
At first be sure you are on the same network
has an IP Address 192.168.12.92, give an IP Address to your terminal (in the
menu Network) like 192.168.12.90 as normally the default subnet mask is set to
255.255.255.0
Second, enter in the Setup Menu
Connections
ate a new connection. Type a connection Name. Choose Connection Type
S-Bus
in the Listbox. Enter the
connect. Then SAVE.
Third, in the configuration Menu, enter the Address of the start page
(dedicated to MB-Panel in S-Bus Mode) and also its
ex. ETHER-SBUS10/start.html.
Manual PCD7.D4xx │ D ocument 26-851 ENG12 │ 2 016-02-05
Ethernet
CAT5 cross cable
Configuration/Communication/
and click on the button Configure. Press on a free button to cre-
S-Bus Station Nr
or equally you can connect your terminal
(refer to chapters 5 and 6):
subnet. For ex. if the Saia PCD
and
TCP/IP Address
html start page name
Quickstart
Communication
device :
®
below
S-Bus
Ether
where to
127.0.0.1
like for
1-12
1
Advertisement
Table of Contents
