Table C-100. Rom Monitor Commands - Nortel 2000 Software Reference Manual

Book C
Command
addr
boot
config
console_
baud
erase
help or ?
image
ipx
lat
mop
net
ping
ports
sequence
slip

Table C-100. ROM Monitor Commands

Arguments
[–d]
[–lv | filename]
[–d | filename]
[–d ]
[–d ]
[–d ]
host_ip_address [data_size]
[npackets]
[–d | [interface [, interface]...]
[–d] [port]
Remote Annex Administrator's Guide for UNIX
Chapter 5 Software Reference Guide
Description
Displays the unit's ROM-resident
Ethernet address in hexadecimal
notation or prompts for values.
Boots and loads Annex operational
code. Only ROM revisions 0600 and
greater with the self-boot option
installed support the –l argument.
Displays the current hardware
configuration and revision levels.
Changes the console port's baud rate
so that it can interface with any
modem to which it is connected.
Erases non-volatile memory.
Displays ROM Monitor commands.
Sets the default image file name.
Sets several parameters associated
with IPX booting and dumping.
Allows you to set the LAT key from
the ROM monitor.
Sets the MOP load/dump address.
Executes a loopback test on the
LAN.
Sends an Internet Control Message
Protocol (ICMP) mandatory
ECHO_REQUEST datagram to elicit
an ICMP ECHO_RESPONSE from a
host or gateway.
Tests the serial line ports.
Edits the load-dump sequence
interface list.
Defines a serial port as a SLIP
interface.
Book C-325