Admin - Nortel 2000 Software Reference Manual

Chapter 3 Using the CLI Commands
Remote Annex Administrator's Guide for UNIX
Book C-132
Table C-39. Privileged Remote Annex VMS Commands (continued)
Command
define server software
initialize server
set unprivileged
set privileged
set server all

admin

The superuser admin command is a local substitute for the host-resident
na command, especially in stand-alone environments. The CLI admin
command set provides a subset of the host-resident na command set. The
syntax is:
admin [command]
Entering the admin command alone at a superuser CLI connection puts
you in administrative mode. The CLI prompt is replaced with the admin
prompt. The attention key or quit command at the admin prompt
terminates the admin session and returns you to the CLI prompt.
Table C-40 describes the CLI admin command set.
Description
Specifies the file name of the Remote Annex
software image.
Reboots the Remote Annex.
Returns the port back to non-privileged status to
inhibit unauthorized use. Enables your port to
perform privileged operations.
Resets the Remote Annex subsystems (security,
LAT, etc.) from the permanent database, re-reads
the macro and service sections of the
configuration file, and re-reads the
message-of-the-day file.
Book C