Inet_Addr; Input_Flow_Control; Table C-23. Valid Options For The Input_Flow_Control Parameter - Nortel 2000 Software Reference Manual

Book C
n
These setting are required because the timer does not start until one of
the following events occur:
1. Input occurs and input_is_activity is set to Y.
2. Output occurs and output_is_activity is set to Y.
3. A port with type set to dial_in starts (regardless of the value of
the control_lines parameter).

inet_addr

This Annex parameter defines the Annex's IP address. This 32-bit address
contains four 8-bit fields separated by periods. Each field contains a
number ranging from 0 to 255 or a hexadecimal number. The IP address
always displays in decimal notation. This parameter has no default.
input _ flow _ control
This asynchronous port parameter specifies the method of flow control
for input received from a device connected to an asynchronous port.
Table C-23 describes the valid options; the default is bell.
Table C-23. Valid Options for the input_flow_control Parameter
Option Description
bell The Annex rings the terminal bell (sends
buffer is full.
eia Flow control is delegated to a lower level (e.g., a parallel port).
The control_lines parameter must be set to flow control or
both, and the device must be wired appropriately.
start/stop Designates flow control by recognizing xon and xoff
characters. This action is independent of the control_lines
parameter setting.
none Disables flow control; characters are lost if the buffers
overflow.
Remote Annex Administrator's Guide for UNIX
Chapter 2 Configuration Parameters
) when its input
^G
Book C-63