At_Nodeid; At_Security; Attn_String - Nortel 2000 Software Reference Manual

Chapter 2 Configuration Parameters
Remote Annex Administrator's Guide for UNIX
Book C-46

at_nodeid

This asynchronous port parameter defines the node ID hint used for an
ARA client during connection establishment. This parameter value is an
AppleTalk address in the form net.node. The valid net values are 0 to
65534. The valid node values are 0 to 254. The default is 0.0.

at_security

This asynchronous port parameter turns on ACP service for an AppleTalk
session on this port. When both at_security and enable_security are
enabled, the Annex uses ACP to get security information about the client,
including authentication, logging, and zone access. If at_security is not
enabled, the Annex uses only local security. A Y enables this parameter,
an N disables it. The default is N.
attn _ string
This asynchronous port parameter defines a control character sequence
that returns users to the CLI prompt. Users can define a temporary control
character sequence using the CLI stty attn command; stty attn ""
disables the sequence. The default is no control character sequence,
displayed as "" the default for virtual CLI connections is
;
If you are running a stats [–sm [ports] | [time]] command with a
defined time interval, the Annex ignores an attention string with
multiple characters.
Book C
.
CTRL-A (^A)