Image_Name; Imask_7Bits; Inactivity_Timer - Nortel 2000 Software Reference Manual

Chapter 2 Configuration Parameters
Remote Annex Administrator's Guide for UNIX
Book C-62

image_name

This Annex parameter defines the file name containing the operational
code that loads by default when you boot an Annex. The string size ranges
from 0 to 100 characters. The default is a null string ("").

imask_7bits

This asynchronous port parameter enables an Annex to mask input to
seven bits. When disabled, the Annex expects eight-bit ASCII input. This
parameter has no effect on transmitted characters. A Y enables this
parameter, an N disables it. The default is N.
SLIP and PPP will not work if this parameter is enabled.

inactivity_timer

This asynchronous port parameter specifies the number of minutes that
a port can remain inactive. If the timer expires, the Annex terminates all
sessions and resets the port.
You can use the input_is_activity and output_is_activity parameters to
define activity as input to the port or output from the port. Setting these
parameters to N causes the timer to run independent of activity. Allowable
values range from 0 to 255. The default is 0 (timer disabled).
If you want a port to reset after a given number of minutes, regardless of
any activity, you must also set the following parameters:
inactivity_timer
input_is_activity
output_is_activity
type
x
N
N
dial_i
Book C