Rip_Routers; Rip_Send_Version; Rip_Sub_Accept; Table C-32. Valid Options For The Rip_Send_Version Parameter - Nortel 2000 Software Reference Manual

Chapter 2 Configuration Parameters
Remote Annex Administrator's Guide for UNIX
Book C-100

rip_routers

This Annex parameter lets you force RIP to direct periodic RIP updates
to a router list rather than broadcasting updates. Valid values are the IP
addresses of up to eight directly reachable routers. The Annex ignores
any address that is not on an attached subnet. Specifying the default, all,
restores broadcasting.

rip_send_version

This Interface parameter controls the RIP version(s) that an Annex sends
over the IP interface(s). Table C-32 describes the valid options for this
parameter. The default is compatibility.

Table C-32. Valid Options for the rip_send_version Parameter

Option Description
1 Version 1 packets are sent to the broadcast address.
2 Version 2 packets are sent to the RIP multicast address.
compatibility Version 2 packets are sent to the broadcast address.

rip_sub_accept

This Interface parameter controls whether or not subnet routes are
accepted over the SLIP, PPP, and Ethernet interfaces. When enabled,
subnet routes are accepted; when disabled, subnet routes are rejected. A
Y enables this parameter, an N disables it. The default is Y.
Book C