Session_Limit; Sigproto; Short_Break; Table C-34. Signaling Protocols - Nortel 2000 Software Reference Manual

Book C

session_limit

This Annex parameter specifies the maximum number of active sessions
the Annex allows at one time. Allowable values range from 1 to 1152 or
none (entering none sets the value to 1152). The default is 1152.
short _ break
This asynchronous port parameter allows an Annex to return a user to the
CLI prompt after receiving a break of less than two seconds. This occurs
only at the CLI level. A Y enables this parameter, an N disables it. The
default is Y.

sigproto

This T1 parameter specifies the inbound and outbound signaling
protocols supported by each T1 channel (DS0). Each channel supports
an inbound protocol and an outbound protocol. Both protocols must be
specified even if they are the same. If the protocol pair is invalid, it is
rejected with an error message. For inbound-only channels, the outbound
protocol must be set to none. For outbound-only channels the inbound
protocol must be set to none. The signaling protocols are as follows:

Table C-34. Signaling Protocols

Protocol
loop_start
ground_start
wink_start
immediate_start
none
Remote Annex Administrator's Guide for UNIX
Chapter 2
Possible Settings
Bidirectional (default)
Bidirectional
Inbound, outbound, or bidirectional
Inbound, outbound
Configuration Parameters
Book C-103