Erase_Line; Erase_Word; Facility_Num; Forward_Key - Nortel 2000 Software Reference Manual

Book C Chapter 2 Configuration Parameters

erase_line

This asynchronous port parameter defines a control character sequence
for the CLI line erase character. The default is .
CTRL-U (^U)

erase_word

This asynchronous port parameter defines a control character sequence
for the CLI word erase character. The default is .
CTRL-W (^W)

facility_num

This Annex parameter identifies a LAT host by number. Allowable values
range from 0 to 32767. The default value is 0.

forward_key

This asynchronous port parameter specifies a character or string that
reopens the next available, higher numbered session already established
at your port. When defining this value, use a unique, unused character
(such as Control F) or a string of characters. To clear an existing setting,
enter a null string (""). The default is no control character sequence.
On virtual (telnet) ports, the forward_key value is limited to one printable
or Control character. If the user tries to set this value to more than one
character, i.e., a string, the setting is ignored and the previous value is
restored.
On non-virtual ports, a forward_key string can range from 1 to 16
characters.
Remote Annex Administrator's Guide for UNIX
Book C-59