Show - Nortel 2000 Software Reference Manual

Book C
Sample command lines for setting port parameters are:
command: set port speed 9600
command: set port data_bits 7
command: set port stop_bits 1
command: set port parity odd
command: set port control_lines none
command: set port type hardwired
command: set port mode cli
command: set port inactivity_timer 120

show

The show command displays current Annex, interface, printer, or port
parameters:
show annex
show interface
show printer
show [port | asynchronous]
show t1
The syntax is:
show annex [=annex_list] [keyword | annex_parameters]
show interface [=interface_list] [keyword | interface_parameters]
show printer [=printer_list] [keyword | printer_parameters]
show [port | asynchronous] [=port_list] [keyword | port_parameters]
show t1 t1_parameter
Remote Annex Administrator's Guide for UNIX
Chapter 1
Displays Annex parameters.
Displays interface parameters.
Displays parallel printer port parameters.
Displays asynchronous port parameters.
Displays t1 parameters.
na Commands
Book C-25