Table C-65. Setting Parameters Using Stty - Nortel 2000 Software Reference Manual

Chapter 3 Using the CLI Commands
Remote Annex Administrator's Guide for UNIX
Book C-196

Table C-65. Setting Parameters Using stty

Parameter Description
attn string Defines a control character sequence as an attention
character or string. Entering this character or string returns
you to the CLI prompt. Make sure the selected control
character sequence is not one that is used with any host
applications. If both break and lbreak are not defined, and
you do not define an attention character or string, you must
log off the host to return to the CLI prompt. The default for
a serial connection is a null string (""); the default for a
virtual CLI connection is
back string Defines a control character sequence as a backward switch
character or string. Entering this character or string reopens
the next lower numbered session, already established at
your port, from within the current session without returning
to local mode. Make sure the selected control character
sequence is not one that is used with any host applications.
To clear an existing switch, enter a null string ("").
On virtual ports, the switch is limited to one character; on
non-virtual ports, the switch string can range from 1–16
characters.
baud value Sets the serial line speed for input and output. Possible
values are: 75, 110, 134.5, 150, 200, 300, 600, 1200, 1800,
2000, 2400, 3600, 4800, 7200, 9600, 19200, 38400, 57600,
115200. The default is 9600.
bchar Defines the data bits per character, not including the start
argument bit, stop bits, or the parity bit (if any). Possible values are:
5, 6, 7, or 8. The default is 8.
break Defines a break as an attention signal. Generally, the break
–break is generated by a key labeled Break. Setting –break turns
off Break as an attention signal.
(continued on next page)
.
CTRL-A
Book C