Tcp_Keepalive (Parallel; Tdi_Distance; Tdi_Framing; Tdi_Line_Code - Nortel 2000 Software Reference Manual

Chapter 2 Configuration Parameters Book C

tcp_keepalive (parallel)

This parallel printer port parameter specifies the length of time a TCP
connection must be idle on one or more specific printer ports. This
parameter overrides the Annex tcp_keepalive parameter for connections
from applications such as aprint or rtelnet to one or more printer ports.
Valid values are 0 to 255 minutes. When set to zero, the keep-alive timer
uses the value set in the tcp_keepalive parameter. When set to 255, the
keep-alive mechanism for the printer port is disabled. The default is 0.

tdi_distance

This T1 parameter defines the distance, in feet, of the cable that runs from
the T1DII to the Private Branch Exchange (PBX) or other equipment.
The parameter setting is an integer from 0 to 655. The default setting is 0.

tdi_framing

This T1 parameter controls which super frame format is used on the T1
Drop/Insert Interface. The parameter settings are d4 (super frame) and
esf (extended super frame). The default setting is esf. The value for
tdi_framing may or may not be the same as tni_framing.

tdi_line_code

This T1 parameter selects the line code to be used on the T1 Drop/Insert
Interface (T1DII). The device connected to the T1DII determines which
line code to use. The parameter settings are ami and b8zs. The default
setting is b8zs.
Remote Annex Administrator's Guide for UNIX
Book C-110