Table C-14. Keywords For The Show T1 Command - Nortel 2000 Software Reference Manual

Book C
Table C-13. Keywords for the show [port |asynchronous] Command (cont'd)
Keyword Parameters
slip local_address, remote_address, dialup_addresses, metric,
slip_ppp_security, net_inactivity, phone_number,
do_compression, allow_compression from the serial group and
subnet_mask, slip_load_dump_host, slip_allow_dump,
slip_mtu_size, slip_no_icmp, slip_tos
timers forwarding_timer, forwarding_count, cli_inactivity,
inactivity_timer, input_is_activity, output_is_activity,
reset_idle_time_on, long_break, short_break
tn3270 printer_host, printer_name
vci login_port_password, login_timeout

Table C-14. Keywords for the show t1 Command

Keyword Description
alarmsyslog Displays parameter setting as yes or no. These values
enable or disable the alarm event syslogs.
bypass Displays parameter setting as yes or no. A setting of
yes removes the T1 engine from the network.
map Displays mappings for the DS0 channels.
ring Displays parameter setting as yes or no. A setting of
yes means that an audible ring is sent to the service
provider for incoming calls.
sigproto Displays the inbound and outbound signaling protocol
settings for each DS0 channel.
t1_info Displays a character string (128 bytes maximum) of
printable ASCII characters that describe installation
information from the service provider.
(continued on next page)
Remote Annex Administrator's Guide for UNIX
Chapter 1 na Commands
Book C-29