Appendix B
CallPilot migration command reference
In this appendix
"Using the CallPilot migration utility" (page 147)
Using the CallPilot migration utility
Introduction
This section describes how to use the commands available in the CallPilot
migration utility.
To determine what commands are available
To view the list of available commands in the CallPilot migration utility, at
the CI> prompt, type help, and then press Enter.
Result:The following information appears:
Commands available:
*CLI
ListMap
Summary
For more help type "HELP <command>" or "HELP all".
•
•
Use KillTape only if the tape drive hangs while the tape is being accessed.
For example, if the ReadTape command fails, you can use the KillTape
command to cancel it.
Copyright © 2007, Nortel Networks
.
Debug
Migrate
TapeTransfer
Note: The following commands are reserved for Nortel use only:
ListMap
Debug
This command generates more output to the console window. It also
generates a migrationtrace.txt file, which contains the input data.
Nortel CallPilot
Meridian Mail to CallPilot Migration Utility Guide
NN44200-502 01.02 Standard
5.0 17 April 2007
DeleteStagingFiles
*MMail2CallPilotMigrReadTapeLabel
KillTape
147