Nortel Callpilot; Meridian Mail To Callpilot Migration Utility Guide; Nn44200-502 01.02 Standard - Nortel Meridian Mail Utility Manual

8
9
10
11
Option 2: To use the existing dialing plan on one system and
create a none- dialing plan on the other system
The following diagram shows an example of this configuration. The diagram
assumes that the Enterprise networking protocol is used between all
systems.
Copyright © 2007, Nortel Networks
.
Running Meridian Mail and CallPilot at the same time 99
Note: Specify the dialing plan as configured on the CallPilot
system (see the configuration diagram on
97) and step 4).
Tip:If the CallPilot site is an NMS site, define the satellite locations
in a similar manner.
Ensure that the Meridian Mail and CallPilot systems are defined
as remote sites in the network database at each remote site, if
both systems must be addressable by other sites in the messaging
network.
a. Modify the dialing plan for the Meridian Mail remote site in the
network database at each remote site. Configure the ESN
prefixes or CDP steering codes to use the overlap as described
in this procedure.
b. Add the CallPilot system as a new remote site to the network
database at each remote site. Specify the dialing plan as
described in the previous steps.
Repeat steps 2–5 until all users are migrated from Meridian Mail
to CallPilot.
Modify the dialing plan information for the Meridian Mail and CallPilot
sites in the network database at each remote site.
Delete the ESN prefixes or CDP steering codes from the
Meridian Mail site configuration, and add them to the CallPilot site
configuration.

Nortel CallPilot

Meridian Mail to CallPilot Migration Utility Guide

NN44200-502 01.02 Standard

5.0 17 April 2007
"Dialing plans" (page
—End—