Nortel Meridian Mail Utility Manual page 37

3
4
5
Copyright © 2007, Nortel Networks
.
Power down Meridian Mail or, if your system has an MMP40 card,
press the reset button on this card.
Tip: Reset node 1 first, and then reset nodes 2 through 5 in
sequence, if applicable.
Wait ten seconds and then power up the Meridian Mail system.
If your Meridian Mail system is a Card Option systems, re-enable the AML
after turning on the power.
Result: Meridian Mail displays diagnostic routines and then pauses
for approximately five minutes while the tape is automatically
retensioned.
Tip: The tape retensioning takes about five minutes. The data
preparation software is loaded from the tape in about one minute.
Monitor the status of the retensioning process by using your watch
to check the time and by listening to the tape drive.
When the data preparation software is loaded, the CallPilot Data
Collection Utility Preparation Menu appears.
Enter the number that matches the release of your Meridian Mail
system and then press Enter.
Result: A confirmation prompt appears.
Nortel CallPilot
Meridian Mail to CallPilot Migration Utility Guide
NN44200-502 01.02 Standard
5.0 17 April 2007
Installing the data collection utility 37
ATTENTION