Staging Area - Nortel Meridian Mail Utility Manual

Networking requirements
If you configure the CallPilot network and assign site and location names
before performing the migration, the migration utility does not update the
CallPilot sites and locations with the Meridian Mail data.
To ensure that the migration utility updates your network with the Meridian
Mail site and location information, change the names of all CallPilot sites
and locations to Untitled before starting the migration.

Staging area

Introduction
The CallPilot migration utility offers you the option to copy the collected
Meridian Mail files to the CallPilot server before starting the migration. The
folder to which the files are copied is referred to as the staging area.
The \nortel\MPCX\Migration\MigrationFiles folder is the staging area.
Nortel recommends that you always transfer the collected files to the staging
area established on the CallPilot server to reduce the migration time.
Copying files to the CallPilot server
The following table contains information on copying data from tapes to the
CallPilot server.
Data set option
All system data
Messages and Contact Center voice
prompts
Messages only
Contact Center voice prompts only
System data (system and
customer profiles, networking
data, restriction/permission lists and
Classes of Service)
User data
Application Builder services
(voice menus, voice services,
and announcements)
Shared distribution lists
Personal distribution lists
Copyright © 2007, Nortel Networks
.
Nortel CallPilot
Meridian Mail to CallPilot Migration Utility Guide
NN44200-502 01.02 Standard
5.0 17 April 2007
Staging area 57
Can be migrated from
Tape Staging area
yes (data tape) yes
yes (message
no
tape)
yes (message
no
tape)
yes (message
no
tape)
yes (data tape) yes
yes (data tape) yes
yes (data tape) yes
yes (data tape) yes
yes
yes (data tape)