Nortel Meridian Mail Utility Manual page 56

56 Chapter 5 Migrating Meridian Mail data to CallPilot
Safety warnings
Tower or rackmount server tape drive
The 201i, 703t and 1002rp server must be equipped with a Tandberg SLR50
internal tape drive. The appropriate tape drive driver must be installed on
the server.
An external SLR75 tape drive is required for the 1005r and the 600r servers.
The Tandberg SLR50 tape drive can read only 2.5-Gbyte tapes, and cannot
read tapes created on Meridian Mail using the Archive Viper tape drive.
Ensure that the tapes containing the Meridian Mail information are 2.5 Gbyte
tapes recorded on a Tandberg SLR4 (TDC4220) or later tape drive.
IPE server tape drive
An external tape drive must be connected to the IPE server, which has a
built-in SCSI connector on the faceplate. The appropriate tape drive driver
must be installed on the server.
The IPE server supports the Tandberg SLR5 (NTRH9038) tape drive. This
tape drive can read the 2.5 Gbyte tapes that are created on a Meridian Mail
system using the Tandberg SLR4 (TDC4220) tape drive.
If a Tandberg SLR5 tape drive is not available, you can temporarily connect the
Tandberg SLR4 tape drive used by the Meridian Mail Card Option system to the
CallPilot server for performing the migration. You must disconnect the tape drive
when the migration to CallPilot is complete.
Copyright © 2007, Nortel Networks
.
DANGER
Risk of electrical shock
Ensure that the tower or rackmount server is powered down before
you attempt any installation or removal of components.
CAUTION
Risk of equipment damage due to electrostatic
discharge
Use an ESD wristband and attach it as follows:
• to the server chassis when performing any work inside
the tower or rackmount server
• to the switch when working with the IPE server
Nortel CallPilot
Meridian Mail to CallPilot Migration Utility Guide
NN44200-502 01.02 Standard
5.0 17 April 2007
ATTENTION
ATTENTION